19740 Tablet PC Holder
INSTALLATION (A-I)
Continuation
F
ATTACHING THE CRADLE
F
15
Place the cradle on the four hooks of the
F 15
swivel joint
F
16
Slide the cradle to the stop position (you will
F 16
hear a click)
G
CLIP THE TABLET PC IN THE CRADLE
G
17
"Move the "small latch" upwards (click!)
G
17
- this allows the arm to be moved upwards
G
17
against a spring tension
G
18.a
Hold the cradle firmly with one hand...
G
18.b
...align the tablet PC centrally in the
G 18.b
clamping jaw and slide upwards until...
G
18.c
...the tablet PC can also be clipped into
G 18.c
the lower side of clamping jaw
G
19
The spring tension of the arm will push the
G 19
tablet PC onto the four moss rubber
G 19
protectors of the clamping jaw
G
20
NOTE:
G 20
The tablet PC should sit neatly with the
G 20
guard arm. The position of the guard arm
G 20
may need to be corrected depending on the
G 20
size of the tablet PC. See
I 25
,
26
&
28
,
29
.
G
21
Now slide the "small latch" down (click!) -
G 21
the upper jaws are now securely fixed
H
REMOVING THE TABLET PC FROM THE CRADLE
H
22
Slide the "small latch" up again - the pull-out
H 22
section is now released
H
23
Hold the tablet PC and use it to push out
H 23
the top side of the cradle
H
24
Unclip the tablet-PC in a downwards motion
H 24
and remove
I
DISMANTLING (Fig.re.)
I
(e.g. to re-position the guard arm
5
)
I
25
Release the lock between the tablet cradle
I 25
and the swivel joint as follows:
I
25.a
Press the lever down and hold down
I
25.b
Slide the tablet cradle upwards to stop
I 25.b
approx. 6 mm
I
25.c
Lift the tablet cradle
I
26
Remove the guard arm
I
27
If required, the supporting arm can also be
I 27
separated from the swivel joint by undoing
I 27
the wing screw
I
DISMANTLING
