INSTALLATION (A-I)
19740 Tablet PC Holder
- Flexible and stable! The ideal presentation for your tablet PC.
- The cradle is an effective and secure mount for tablet PCs with a screen size 6 to 10.1"
- A universal clamping jaw with integrated moss rubber protectors ensures a strong grip, eliminates undesired
-
vibration sound problems and protects the tablet housing
- Equally suitable for the stage, home or studio
- A large clamp secures the holder on tubes between ø 11 - ø 30 mm
- The holder is very flexible and can be adjusted to suit a range of tablet sizes,
-
tilt, direction, portrait or landscape format
SAFETY NOTES
- Use a suitable stand - the stand must be stable, able to accommodate the weight and have a
-
tube ø 11-30 mm
-
e.g. K&M Stands 118/1 et seq., 11888, 11889, 199, 200, 21020, 21090, 210/6, 210/8, etc.
- Clip the tablet carefully into the holder and check it is held securely
- Manoeuvre the holder with care, particularly when adjusting (tilt, format and direction) and always
-
ensure that the tablet is held securely in the cradle
Thank you for choosing this product. These instructions contain information about the installation
and use of the tablet PC holder. We suggest you keep the instructions in a safe place for later use.
A
PREPARE THE STAND (see Safety Notes above)
B
LAY OUT THE COMPONENTS FOR 19740 IN
ORDER
B
1
Tablet cradle
B
2
Supporting arm with clamp (for tubes ø 30 mm max.)
B
3
Swivel joint
B
4
Wing screw with rubber washer
B
5
Guard arm
C
PRE-ADJUSTING THE TABLET CRADLE
C
6
Ensure that the "large latch" is disengaged -
C
6
look for the 3 mm gap (see Fig.)
C
6
Slide the "large latch" upwards, applying gentle
C
6
strength. There will be an audible click.
C
7
Slide out the upper section:
C
7
The distance between the sides should be
C
7
approx.10-15 mm less than the height or width
C
7
of the tablet PC.
C
8
Slide the "large latch" back down (there should
C
8
be an audible click)
D
CONNECTING THE SUPPORT ARM TO THE SWIVEL JOINT
D
1
9
Insert the wing screw into the bore hole from
D 1
9
under the supporting arm,
D
10
Position the rubber washer above the thread
D
11
Screw the wind screw into the swivel joint
D
12
Hold the supporting arm clamp on the tube
D 12
and fix by tightening the knurled screw.
E
ATTACHING THE GUARD ARM
E
13
Place the guard arm in a suitable groove of the
E 13
swivel joint in such a way that the end sits closely
E 13
with the tablet (
13a
)
E
14
Important:
E 14
The tablet PC must be aligned centrally
E 14
(see points
28
and
29
), if necessary, correct the
E 14
position of the guard arm.
T
ablet PC
tube
