USAGE NOTES / FUNCTION
MAINTENANCE, CLEANING
- in the case of maintenance work remove any equipment first.
- always be aware of potential risks, e.g. danger of pinching or
-
wedging fingers in case of moving parts.
- to care for the product, use a damp cloth and non-abrasive
-
cleaning agen
FAULT-FINDING (F) and REPAIR (R)
F: Universal holder is not stable:
F:
B: The stand tube is not properly screwed into the
F: B:
snap-in bracket
3
F:
B: Back gear between the bracket and disk are not
F: B:
engaged properly
3.a
F:
B: The snap-in bracket is loose on the stand support arm
11
F:
B: The keyboard stand is not stable (due to surface, stand
F: B:
condition, etc.)
F: The equipment is not stable:
F:
B: Check the connection between the connection thread
F: B:
and the equipment
F:
B: Check the equipment
CONNECTOR THREAD
12
Install securely: 3/8" with the suitable knurled washer
13
Additional adapter for 5/8" - if needed screw onto 3/8"
TYPICAL ANCILLARY PRODUCTS / WEIGHT BEARING LOADS
14
Music desk,
15
iPad stand holder
16
Tablet PC stand holder
17
Gooseneck
18
Boom arm
ADJUSTMENT OPTIONS
We recommend prior to the adjustment of the universal holder
that valuable equipment be removed (e.g. Tablet).
19 HEIGHT
19
a. Hold the stand tube, unscrew and remove the clamping
19
a.
knob from the snap-in bracket, the locking disk
19
a.
and spring remain on the threaded bolt.
19
b. Select the desired drill hole on the stand tube (8x) and
19
b.
using the clamping knob place the snap-in bracket back
19
b.
on the support tube.
19
c. The 8 levels in 42 mm intervals provide for height
19
c.
adjustments from 120 to 415 mm.
20 SIDE ANGLE
20
a. The stand tube should always be in a vertical position.
20
b. Adjustments to the X-Stand change the angle of the stand
20
b.
tube and requires adjustments to be performed.
20
c. The stand tube can be adjusted with the back gear of the
20
c.
locking pin and disk in 8° steps.
20
d. Hold the stand tube, loosen the Clamping knob a bit until
20
d.
the teeth are no longer engaged, place the stand tube in
20
d.
the desired position and tighten the Clamping knob.
20
e. The 8°- levels of the back gear can result in the stand tube
20
e.
being tilted up to 4°. This can be corrected through adjusting
20
e.
the snap-in bracket:
20
e.
Loosen the screw - adjust the bracket - tighten the screw.
21 TRANSPORT / PACKAGING
21
The holding tube can be collapsed and folded with a small
21
footprint. Procedure please refer to Section
20.d.
TECHNICAL DATA
Material
Stand tube: Steel, powder coating, black
Snap-in bracket and locking disk: Zinc die-cast,
powder coating, black
Thread: Steel, galvanized
Handles, caps: Plastic, PA, PE, black
Load
Music desk, boom arm, gooseneck, iPad stand
holder, Tablet PC stand holder, etc.
Dimensions
ø 25 x 450 mm, Height: 125-420 mm
in 8 levels, 3/8" and 5/8"
Packaging
Box: 580 x 80 x 50 mm
Weight
0.7 kg
CONNECTOR THREAD
ANCILLARY PRODUCTS / WEIGHT BEARING LOADS
HEIGHT
TRANSPORT / PACKAGING
SIDE ANGLE
