Material
Tubes: Steel, powder coating, black
Seat mechanic, pneumatic spring Steel, diverse
Connection elements: Steel, galvanized
Caps, grips, guides: PA, PE
Cushion covering: Trevira CS (flame retardant)
Load
1 Person, 100 kg (static load)
Dimensions
W x D x H: 545 x 495 (515) x 710 (980) mm
Seat surface: 440 x 440 mm; Seat height: 480 - 530 mm
Box
W x D x H: 600 x 600 x 640 mm
Weight
net: 12.5 kg; gross: 14.7 kg
KÖNIG & MEYER
GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
13440-000-55 Rev.04 03-80-334-00 8/17
TECHNICAL DATA
CHAIR SEAT: Height
CHAIR SEAT: Angle
BACKREST: Height
BACKREST: Cushion
CHECK, MAINTENANCE, CLEANING
- In the event of maintenance pay attention to possible
-
risks (wedging…)
- To care for the product, use a damp cloth and a non-
-
abrasive cleaning agent
FAULT-FINDING (F) and REPAIR (R)
F: Orchestra chair is not stable
F:
R: Check if the surface is suitable
F:
R: Is the orchestra chair in good condition? (Base, gliders)
F: The chair i.e. back rest is too high/low/etc.
F:
R: Change the settings (pay attentions to the limits)
F: Chair stack is not stable
F:
R: Ensure that only the maximum number of chairs
F: R:
are stacked: 4
F:
R: Re-stack the chairs carefully
F:
R: Check the condition of the chairs
USAGE NOTES
and FUNCTIONS (8-19)
ADJUST the CHAIR SEAT
HEIGHT:
8
Lift the right front lever
R1
8
a. Lower the seat: Put weight on the seat
8
b. Lift the seat: Don’t put weight on the seat
NOTE: To select seat position take hand off lever This
applies to all positions. The position can be adjusted
variably.
ANGLE:
9
Pull on the left lever
L
and hold in place and lean on the
9
chair seat the angle of the seat can be changed:
9
a. body weight back (-6°) i.e.
9
b. body weight front (+2°).
NOTE: To select seat angle let go of the lever
8
.
ADJUST the BACKREST
HEIGHT:
10
Hold the backrest and loosen the clamp screw.
11
Then adjust the holding tube to the desired height and
11
secure the position of the backrest by tightening the
11
clamp screw.
12
The maximum height of the backrest is limited by the
12
locking pin.
12
See Section Installation, Pos.6
CUSHION:
13
The backrest cushion is affixed to the holding tube, and
13
can swivel by approx. 30°.
14
A preset position is not necessary because the cushion
14
automatically adjusts to the back of the user.
ANGLE:
15
Press the lever located on the right in the back
R2
15
downwards…
15
…and the backrest swings to the front.
16
By pressing your back onto the cushion, the desired
16
position (max. -24°) can be reached, which…
17
…can be set by pulling the lever
R2
up.
STACKING
18
The orchestra chair can be stacked thanks to the side
18
support arms.
19
Up to 4 orchestra chairs can be stacked professionally
19
and solidly.
BACKREST: Angle
STACKING (up to 4 chairs)
