Konifera BW73000SKD 2 x 1,2 m, Руководство по сборке

Страница: 25 / 63

Page EN-6 Assembly
Before getting started:
• Read the chapter “Safety” from
page EN-2.
• Unpack the product as described in chap-
ter “Check the delivery” on page EN-5.
Determine the installation
height
1. Measure the height from floor to ceiling
to determine the installation height of the
awning. The installation height can be
adjusted between 192 cm and 312 cm
( Fig. 3 ).
Awning canopy
1. Insert the Keder cord (13) into the upper
seam of the awning canopy (18) ( Fig. 4 ).
2. Unscrew the screws (19) and (20) from
the downpipe elements (10) and (11) and
store them carefully ( Fig. 5 ).
3. Screw the downpipe elements (10)
and (11) together ( Fig. 6 ).
4. Insert the connected downpipe (22) into
the lower seam of the awning canopy (21)
( Fig. 7 ).
Canopy
1. Insert the connector (4) into the right can-
opy pole element (3), until the first two
holes on the connector and the holes on
the canopy pole element are in line with
each other ( Fig. 8 ).
2. Screw the two ST3.9×15 screws (14)
through the holes provided to fix the con-
nector ( Fig. 8 ).
3. To stretch the awning canopy over the
canopy pole, insert the upper seam of
the awning canopy (18) with the inserted
Keder cord (13) first into the groove (23)
on the left canopy pole element (1) and
then into the groove on the right canopy
pole element (3) ( Fig. 9 ).
4. Push the canopy pole connector (4) into
the left canopy pole element (1) and
Assembly
screw the two ST3.9×15 screws (14)
through the holes provided to fix the con-
nector. Make sure that the upper seam of
the awning canopy remains taut ( Fig. 10 ).
The canopy pole (24) is now assembled.
Awning frame
CAUTION
Risk of injury!
The extensions can move and may
swing uncontrollably.
■ Hold on to the extensions while as-
sembling the awning frame.
1. Push the extension pole (5) through the
left and right plastic clamps (25) on the
canopy pole (24). Make sure that the
hand crank (2) hangs down or is parallel
to the extension pole ( Fig. 11 ).
2. Put the ceiling brackets (17) on top of the
extension poles (5) (
Fig. 11
).
3. Screw the fixing rings (26) of the ex-
tensions (7) temporarily to the feet (6)
and (9) ( Fig. 12 ).
4. Insert the extension poles (5) into the feet
(6) and (9). Make sure they are the right
way around. The screws on the fixing
rings must point outwards. ( Fig. 13 ).
5. Fix the extension poles (5) by using the
M6×35 bolts (16) and the nuts (15) at the
same height on both sides.
The combined length of the extension pole
and foot should not be more than 4 cm
shorter than the distance you determined
in step 1 ( Fig. 14 ).
6. Set up the awning in the desired position.
Make sure that the canopy pole (24) is
horizontal and the feet (6) and (9) are ver-
tical ( Fig. 15 ).
7. To extend the feet and tension them be-
tween the ceiling and the floor, turn the
foot caps clockwise ( Fig. 15 ).