Konica Minolta magicolor 1600W, Руководство по обслуживанию

Страница: 95 / 216

9. Remote panel utility (Only for magicolor 1600W)
Field Service V er. 1.0 Nov. 200 8
58
magicolor 1600W magicolor 1650EN
Adjustment / Setting
9.4 Service Mode Tab
A. Procedure
• Press the following key in this order
1. Press the [Tab] key.
2. Press the [Alt] key + [a] key.
3. Input the “KMADMIN”.
NOTE
• Make sure to enter “KMADMIN” with bit letter.
9.4.1 Enable Warming
A. Toner Low
B. I/C Low
9.4.2 Temperature
9.4.3 BK Clear
Function • Specifies whether a printer indicator blinks or a warning message appears in the sta-
tus display box of the Remote Panel Utility when toner is about to run out. If Off is
selected, neither of these notifications appear when the toner is about to run out.
Use
Adjustment
Range • The default setting is On.
“On” / Off
Function • Specifies whether a printer indicator blinks or a warning message appears in the sta-
tus display box of the Remote Panel Utility when imaging cartridge is about to run
out. If Off is selected, neither of these notifications appear when the imaging car-
tridge is about to run out.
Use
Adjustment
Range • The default setting is On.
“On” / Off
Function • To adjust the fusing heating temperature individually for each paper type so as to
ensure good fusing performance that varies with varying environmental conditions.
Use • When fusing performance is poor, or wax streak or offset occurs when the type of
paper is changed or environmental conditions change.
• Use this function when curled paper, or paper misfeed as a result of the curled paper,
occurs under varying environmental conditions or depending on the type of paper
used.
Adjustment
Range • The default setting is 0.
Plain Paper: -10 / -5 / “0”
Thick Paper: -10 / -5 / “0”
ENVELOPE: -10 / -5 / “0”
Function • To clear engine information backup data
Use • Execute this function to synchronize data when the MFP board or the printer control
board is replaced with a new one.