78
Error message
●
If the number of remaining frames on the status LCD displays “Err” and all status LED flash
an error has occured. In this case, perform the following procedure.
(1)
Set the main switch to OFF.
Set the main switch to other than OFF. If camera functions are not restored:
(2)
If using the AC adapter, disconnect it. (See page 17.)
(3)
Remove all batteries. (See page 16.)
(4)
Install new batteries. (See page 16.)
If the error persists even after performing the above procedures, contact the dealer from
whom you purchased the camera or a Konica Service Station.
For inquiries concerning repair, handling and care, contact the dealer from whom you pur-
chased the camera.
Symptom
Check
page
Cannot play back
Battery dies after
very little playback
Correct date is not
displayed when
turning on power
Cannot transfer
images to PC
Others
Playback
• Main switch is not set to
.
46
• Images were continuously shot.
26
• SD Memory Card/Multi-Media Card recorded
with images is not inserted.
46
• All images on the SD Memory Card/Multi-Media
Card have been deleted.
51, 63
• The battery is not new (low battery).
17
• AA alkaline batteries are being used.
11, 17
• Battery polarity or metal parts of camera are dirty.
11, 17
• The backup time during battery replacement is
20
about 15 minutes. The date must be set again
if this limit has been exceeded.
• Camera is not correctly connected to the PC.
67
• The main switch of the camera is set to OFF.
71, 72
Содержание Digital Revio KD-210Z
Страница 81: ...81 Appendix 8...
Страница 82: ...82...