E-11
<PC-201>
5. Display the Tech. Rep. Mode screen.
(For details of how to display the Tech. Rep.
Mode screen, see the service manual.)
6. Select the function to be used as follows:
Machine Adjust
→
PRT Area
→
Left Margin
→
3rd.
* Perform the same adjustment procedure also for
the “4th.”
7. Measure width A on the test pattern produced to
check to see if it falls within the specified range.
Specifications: 3.0 ± 1.0 mm
8. If the measured width falls outside the specified
range, adjust with “
▼
” or “
▲
” key and then make
the check again.
<AD-501>
9. Display the Tech. Rep. Mode screen.
(For details of how to display the Tech. Rep.
Mode screen, see the service manual.)
10.Select the function to be used as follows:
Machine Adjust
→
PRT Area
→
Dup. Left Margin
→
1st.
11.Measure width A on the backside of the test pat-
tern produced to check to see if it falls within the
specified range.
Specifications: 3.0 ± 1.0 mm
12.If the measured width falls outside the specified
range, adjust with “
▼
” or “
▲
” key and then make
the check again.
13.Perform the same procedure for all paper feed
units.
A
A