E-2
2. Installation procedures
(1) Turn OFF the power switch and unplug the
power cord from the power outlet.
(2) Attach the ferrite core as shown in the illustra-
tion.
Note:
• Install the ferrite core by winding the cable two
turns.
• Place the ferrite core approximately 60 mm
away from the authentication unit.
(3)
<When the Working Table WT-506 is mounted to the
main body>
Refer to the installation manual for the Working
Table WT-506 and remove the working table.
(4) Remove the cover from the working table.
(Three screws)
Note:
The cushion, cable tie, and authentication label
are contained inside the cover.
(5) Paste the cushion to the cover, aligning the
cushion with the line marked inside the cover.
Note:
The cushion is supplied with the working table.
(6) Position the authentication unit, aligning its four
corners with the four marks indicated on the
underside of the working table.
(7) Secure the authentication unit cable to the work-
ing table plate with the cable tie.
Note:
• The cable tie is supplied with the working table.
• Cut the excess portion of the cable tie.
(8) Attach the cover removed in step (4).
(Three screws)
Note:
Put the ferrite core inside the cover.
Line
Mark
Cable tie