Konica Minolta 0902, Руководство по обслуживанию

Страница: 61 / 302

Chapter 3 Troubleshooting
3-7
3.2.2 06050 ~ 06090: Receiver Motor Errors
•
Error codes S column: Errors at the read operation/calibration.
•
Error codes E column: Errors during erase operation.
•
Error codes I column: Errors during initialization.
Error code Description of the error Response
(References to replacement methods are
listed at the end of the table.)
S E I
06050 06065 06080 Receiver HP sensor error
(when moving to HP)
Receiver HP sensor did not go
ON when the receiver was
moving to the home position.
Confirm following and replace the faulty parts.
•
Receiver HP sensor
•
Sensor wire: JP43 ~ MCN3 (MDU)
•
Receiver motor
•
Motor wire: JP51 ~ MCN5 (MDU)
•
MDU
06051 06066 06081 Receiver motor control error
(when moving to HP)
There was a trouble with the
motor control when the receiver
was moving to the home position.
Confirm following and replace the faulty parts.
•
Receiver motor
•
Motor wire: JP51 ~ MCN5 (MDU)
•
MDU
06052 06067 06082 Receiver HP sensor error
(when moving to first falling
position)
Receiver HP sensor did not go
OFF when the receiver was
moving from the home position
to the first falling position.
Confirm following and replace the faulty parts.
•
Receiver HP sensor
•
Sensor wire: JP43 ~ MCN3 (MDU)
•
Receiver motor
•
Motor wire: JP51 ~ MCN5 (MDU)
•
MDU
06053 06068 06083 Receiver motor control error
(when moving to first falling
position)
There was a trouble with the motor
control when the receiver was
moving from the home position to
the first falling position.
Confirm following and replace the faulty parts.
•
Receiver motor
•
Motor wire: JP51 ~ MCN5 (MDU)
•
MDU
06054 06069 06084 Receiver motor control error
(when moving to second falling
position)
There was a trouble with the motor
control when the receiver was
moving from the first falling position
to the second falling position.
06055 06070 06085 Receiver motor control error
(when moving slightly down
at the second falling position)
There was a trouble with the
motor control when the receiver
was moving down slightly at the
second falling position.
06056 06071 06086 Receiver motor control error
(when moving to first falling
position 2)
There was a trouble with the motor
control when the receiver was
moving from the second falling
position to the first falling position.
06057 06072 06087 Receiver HP sensor error
(when moving to HP 2)
Receiver HP sensor did not go
ON when the receiver was
moving from the first falling
position to the home position.
Confirm following and replace the faulty parts.
•
Receiver HP sensor
•
Sensor wire: JP43 ~ MCN3 (MDU)
•
Receiver motor
•
Motor wire: JP51 ~ MCN5 (MDU)
•
MDU