Konami PODIUM KP3, Руководство оператора

Страница: 16 / 20

2-2 © 2010 Konami Gaming Inc. P/N 810061
PODIUM KP3
SECTION 2 - SET-UP & OPERATIONS
Installing the Candle
Open the Top Box Door. Pass the connector of the Candle
through the “Z” shaped hole in the top of the Top Box. Then, mount
the Candle inside the top box using the two (2) UNC 8-32 screws.
Connect the Candle connector so that the Candle stays horizontal. If
so equipped, secure the frame ground (FG) wire of the Candle with
one of the 8-32 screws. Close and lock the door. Turn the power on
and verify that the Candle illuminates.
NOTE:
If the Tower Light is not required, order P/N
191050 (Cover, Candle Mounting).
Stand Drill Guide
8.500
15.00
4.074
1.648
21.88
14.949
2.50 DIA
12.448
(6x) .375 DIA
.806 8.828
14.027
19.228
20.268
2.12 SQ
R .12
CTR
10.94
(ALL DIMENSIONS ARE IN INCHES)
BACK
DROP
HOLE
POWER
CORD
HOLE
NOTE: To ensure proper spacing between machines, the
minimum allowable width of the stand a Konami machine
can be mounted on is 28”.
Candle Pin Assignment
CANDLE PIN ASSIGNMENT
PIN NUMBER WIRE COLOR SIGNAL ASSIGNED LIGHT LOCATION
1 BROWN TL0 BOTTOM
2 BLUE TL1
TOP
3 VIOLET TL2
4 GREY TL3 RESERVED
5 N. C. N. C.
6 YELLOW +24 V
Drop Box Switch
NOTE: The Drop Box switch wiring is typically used ONLY
when the machine is not connected to a slot accounting
system.
Open the Main Door. Locate the connector labeled DROP (on
the main cabinet harness). Connect the optional Drop Switch Harness
(P/N 110324). Connect the three spade connectors to the Drop Switch.
Check Drop Switch Operations
If the following problem arises after turning the power on, check
that the Drop Box Switch is installed properly.
• The 031 DROP DOOR ACCESSED error message is
not displayed even after the power is turned on again
with the drop-door closed.
• The 041 DROP DOOR PORT error message is
displayed.
• No error messages appear when the Sub-Door is
opened and closed.
A Drop Door open accessed error can be detected even with
the power turned off. Reset the error and turn the power on to check
that the switch is installed correctly.
DROP BOX SWITCH PIN ASSIGNMENT
PIN # PIN ASSIGNMENT DESCRIPTION
1 GND GND (COM)
2 SW_DROP
SECURITY
(SW DROP BOX DOOR (N.O.))
3 BSW_DROP
SECURITY
(SW DROP BOX DOOR (N.C.))
4 N. C. -