Konami Bass Angler, Руководство оператора

Страница: 17 / 37

15
1P connector
Ground cable
connector
Acccompanying
I/O cables
Reel unit
Connector
Clamp
1P connector
Ground cable connector
Acccompanying
I/O cables
2 Setting the kit in the machine
6
Attach the reel-fitted control panel
with the screws (removed in Step 5).
At this time, fit the reinforcement to
the spot shown at right using the
accompanying square-neck screw.
7
Loosen the clamp, lay the accompanying
I/O cables (in Step 3) as shown at
right, and connect them to the 4
connectors of the reel unit.
8
Connect the 1P connector and the
ground cable connector, both coming
from the reel-fitted control panel, to
the points of the machine shown at
right.
•Preferably apply commercially available
screw loctite to all the screws.
MEMO
9
Slowly close the machine’s panel with care not to get the cables caught.
10
Carry out “3-1 PCB start-up check (self test)” on page 17.
11
Finally check the reel and button performance on the “I/O CHECK” screen on page19.
Flange nut
(6 locations)
Square-neck screw
(M4x20L)
Clamp Control panel reinforcement
•Bundle the cables neatly with the clamp.
MEMO