SETTING THE CONTROLS ON THE KOMET AMBIKAB
:
1.
The
Effects Send Level
control determines the amount of signal sent to the effect's units.
Set this control to allow for sufficient signal levels to drive the effects unit without
clipping. Some effects will have a clipping indicator, on others you will have to use your
ears. If the effects signal is distorting, back off the Effects Send Level. Remember that
the AmbiKab
sends a portion of the speaker signal to your effects unit. The higher your
playing volume, the more signal is being sent. This means that quieter playing situation
and lower wattage guitar amplifiers will call for higher settings of the Effects Send Level,
and vice versa.
2.
The
Effects Volume
control determines the volume of the effect(s) that is coming out of
the AmbiKab's
effects speakers. In essence, this is your effects level control
3.
The
Effects Bass Cut
control can be used to reduce the bass content of the wet signal
only. It does not affect the dry guitar signal.
EXTREME SETTINGS:
The AmbiKab
is designed to work with a very wide variety of amplifiers and effects. There can
occasionally be situations where extreme settings, such as Effects Send Level and Effects
Volume controls turned up all the way in combination with effects units capable of sending
extreme levels of signal, can create an internal feedback condition.
This may manifest itself as
a sustained howling or bass oscillation noise
. If you encounter this, engage the Bass Cut
control and/or reduce Effects Volume until the oscillation noise stops.
TROUBLESHOOTING:
Pilot Light Not On
:
Check to see if the amplifier’s AC cable is plugged in at wall and plugged in at the IEC
connection on the back panel of the amp
No Sound
:
Check the speaker connection at back of amp and at the input of the speaker cabinet.
(continued)
Copyright 1999-2017, Komet
Amplification. Group, L.L.C. May not be reproduced in any form without express written consent from Komet
Amplification.
