Komatsu PC490-11, Инструкция по установке и эксплуатации

Страница: 392 / 492

1.
Turn valve (1) at the bottom of the fuel tank to CLOSE po-
sition (S).
2.
Open the engine hood.
3.
Place a container under fuel pre-filter cartridge (2) to re-
ceive the fuel.
4.
Loosen drain valve (3) and drain water and sediments
from transparent cup (4), and also drain all the fuel from fil-
ter cartridge (4).
5.
Remove drain hose.
6.
Turn filter cartridge (2) counterclockwise by using the filter
wrench, and remove it.
7.
Make sure that drain valve (3), which is provided in the
lower part of transparent cup (4) of the new filter cartridge,
is firmly tightened.
Tightening torque: 2.5
～
3.4 Nm {0.25 to 0.35 kgm}
8.
Clean the filter head, fill the new filter cartridge with clean fuel, thinly apply oil to the packing surface, then
install it to the filter head.
NOTICE
• When filling the filter cartridge with fuel, do not re-
move cap (B). Always fill with fuel from small
holes (A) (8 places) on the dirty side.
• After filling with fuel, remove cap (B) and install
the fuel filter.
• Always fill with clean fuel. Be careful not to let any
dirt or dust get into the fuel. In particular, centre
portion is the clean side, so do not remove cap (B)
when filling with fuel. Be careful not to let dirt or
dust get into the centre portion on the clean side.
9.
When installing the cartridge, tighten it until the packing surface contacts the sealing surface of the filter
head, then tighten it 1/2 to 3/4 turn.
REMARK
If the filter cartridge is fastened too much, the packing will be damaged and this leads to leakage of fuel. If
the filter cartridge is too loose, fuel will also leak from the packing. Therefore, be sure to observe the fasten-
ing angle.
When tightening with a filter wrench, be extremely careful not to dent or damage the filter.
10. Install drain hose.
MAINTENANCE PROCEDURE MAINTENANCE
4-52