Komatsu PC360LC-11, Руководство по эксплуатации и техническому обслуживанию

Страница: 69 / 516

HANDLE BATTERY
Before inspecting or handling the battery, turn the key in the starting switch to OFF position and check that the
system operating lamp is off. Then set the battery disconnect switch to OFF position and remove the switch key.
Danger of battery exploding
When the battery is being charged, flammable hydrogen gas is generated and may explode. In addition, the bat-
tery electrolyte includes dilute sulphuric acid. Any mistake in handling may cause serious personal injury, explo-
sion, or fire, so always observe the following.
• Do not use or charge the battery if the battery electrolyte is below LOWER LEVEL mark. This may cause
an explosion. Always perform periodic inspection of the battery electrolyte level, and add purified water
(such as a commercial battery fluid) to UPPER LEVEL mark.
• Do not use a dry wipe to clean the battery. A wet wipe will prevent fire or explosion from static electricity.
• Do not smoke or bring any open flame close to the battery.
• Hydrogen gas is generated when the battery is being
charged, so remove the battery from the machine, take it
to a well-ventilated place, remove the battery caps, then
perform the charging.
• After charging, tighten the battery caps securely.
Danger from dilute sulphuric acid
When the battery is being charged, flammable hydrogen gas is
generated and may explode. In addition, the battery electrolyte
includes dilute sulphuric acid. Any mistake in handling may
cause serious personal injury, explosion, or fire. Always ob-
serve the following.
• When handling the battery, always wear protective eye-
glasses and rubber gloves.
• If battery electrolyte gets into your eyes, immediately wash
your eyes with large amounts of fresh water. After that, get
medical attention immediately.
• If battery electrolyte gets on your clothes or skin, wash it
off immediately with large amounts of water.
Danger of sparks
Sparks may be generated and they can cause a fire. Always observe the following.
• Do not let tools or other metal objects make any contact between the battery cables. Do not leave tools
lying around near the battery.
• When removing the battery cables, turn the starting switch to OFF position and, after checking that the sys-
tem operating lamp goes out, set the battery disconnect switch key to OFF position and pull it out.
When removing the battery cables, remove the ground cable (negative (-) cable) first. When installing, con-
nect the positive (+) cable first, then connect the ground.
• Tighten the battery cable terminals securely.
• Secure the battery firmly in the specified position.
PRECAUTIONS WHEN USING HAMMER
When using a hammer, pins may come out or metal particles may be scattered. It is dangerous and may cause
serious personal injury or death. Always observe the following.
• When hitting pins or bucket teeth, broken pieces may be scattered, and it may cause personal injury to the
people in the surrounding area. Always check that there is no one in the surrounding area.
,&
SAFETY PRECAUTIONS FOR MAINTENANCE
2-47