Komatsu Utility PC26MR-3, Руководство по эксплуатации и техническому обслуживанию

Страница: 82 / 252

INSTRUMENTS AND CONTROLS
80 WEAM009500
6. Travel levers (with pedals)
WARNING
q
Before carrying out any manoeuvre with these levers, the
operator must seat in the work position and fasten the seat
belt.
q
Before moving the machine, make sure that the sprocket
(A) is positioned at the rear of the machine and that the
safety locks are engaged; if the turret is rotated by 180°, the
controls are inverted (see "3.3.4 HOW TO MOVE THE MA-
CHINE" e "3.3.5 STEERING THE MACHINE").
q
Use the travel control pedals only when the machine is
moving. If a pedal is inadvertently pressed when the ma-
chine is not moving or steering, this may move suddenly
and cause serious accidents.
q
When travelling or carrying out steering manoeuvres, use
the pedals with the maximum care.
q
When leaving the operator seat, always rotate the pedals to
the rest position, in order to avoid pressing them by mis-
take.
These levers are used to operate the travel motors (right and left)
and control the forward and reverse travel according to the move-
ments indicated.
(a) FORWARD: levers pushed forward
(b) REVERSE: levers pulled towards the operator
N (Neutral): machine at rest.
NOTE
q
If the levers are in the forward or reverse position, the sound
alarm goes off to warm that the machine is moving.
q
When it is necessary to use the travel pedals, the opening oper-
ation must be carried out by the operator while correctly seated
in driving position. After use, always rotate the pedals to the rest
position (closed).
IMPORTANT
q
When the safety lever is in the “locked” position, all the
movements are inhibited (see "3.2.3 pos: 1. Safety lever
(control locking lever)").
a
b
a
a
a
b
b
b
N
N
RKA16620
RKA16630