KC3 PV Charge Controller Instruction Manual
8
when Lighting Mode is
on but Timing Mode is
off, or under Timing
Mode
7 PV_ON_V
Lighting control
on(off) Voltage
V X
．
X
4.0 / 8.0
Set within 4.0V-8.0V
(automatically doubled in
24V system)
8 PV_DLY_T
Switch Delay
time(mins) when Full
lighting control
voltage
M XX 03
1mins-59mins, available
when lighting control on
or off.
Instruction: See above table
1)
No.1
“Current time” is for setting the right time. When under this status, the time shown is
the current system time. It is a “24 hours” mode. It will be back to factory setting if you set
unreal time or when power turn-off, you need to reset the time when you the power turn-on.
2)
No. 2
is set for batteries in different capacity, the setting affects the charging time as well.
3)
No. 3
is set to pause charging when battery voltage exceeds to this set voltage.
Re-charging starts at a low current when the battery voltage is back to charging voltage,
4)
No. 4
is set to disconnect the load when the battery voltage is lower than this set voltage.
The users shall set the “discharging cutout voltage” according to the actual discharging
current.
It means:
1). Set a lower “discharging cutout voltage” when discharging current is big.
2). Set a higher “discharging cutout voltage” when discharging current is small.
The settings for
No. 2, No. 3, No. 4
, please reference the specifications of batteries.
5)
No. 5
is “Working Mode”, it has: 4 modes which mentioned above.
PV
: Lighting Mode (Default Mode)
PV+TIME
: Lighting Control on + Time Mode
TIME
: Timing Mode
MANUAL
: Manual Switch Mode
6)
No. 6
is to set the time for on & off. Time for “on” is available under Timing Mode, not
available for other modes. Time for “off” is available under when Lighting Mode is on
but Timing Mode is off, or just under Timing Mode