Manual EDU 2AE/TOP e EDU 2AE/TOP/TA Rev.1.1
Page 8
24) Torq max
–
Maximum Torque:
The minimum torque and maximum torque options allow the user
to set the acceptable torque range for the single application. When the reached torque is inside this range,
“right screwing” will be displayed on the status bar and the green led will light up. The messages “below
minimum torque” or “over maximum torque” will be displayed if the reached torque is outside this range.
You can set the torque range from 0 to 40 Nm at intervals of 0.01 Nm.
The maximum torque option allows to set the highest value of the torque range and
it’s on if the calibration
is ON. If the calibration is OFF the maximum torque value automatically sets on 40 Nm.
25) Ins. barcode:
to scan a barcode and recall the desired program. To be used in combination with option
4. of the Sequence Menu.
THE FOLLOWING MENU IS AVAILABLE ON T&A VERSION ONLY
26) Func T&A
–
T&A function mode:
You can activate the Torque & Angle function. Set OFF if you
don’t need
this function. If you set ON you can choose among six working conditions (see T&A specific
instructions).
- - - - - M E N U - - P R : 1 - - - - -
2 7 ) S t a r t i n g
T o r : - - -
2 8 ) A n g .
m i n :
- - -
2 9 ) A n g .
m a x :
- - -
27) Starting Tor
–
Starting torque:
If T&A option is set on Tor mode (See T&A paragraph), you can
set the torque threshold the angle starts to be read from. If T&A is set on angle mode (see T&A paragraph),
you can set the torque threshold the angle starts to be carried out from.
28) Ang. min
–
Minimum angle:
Minimum angle threshold. You can set it if T&A is set on Tor, T/in or
T/lv (see T&A specific instructions). The minimum angle the operator can set is 5°.
29)Ang. max - Maximum angle:
Maximum angle threshold. You can set it if T&A is set on Tor, T/in or
T/lv (see T&A specific instructions). The maximum angle the operator can set is 9720°.
If T&A is set on Ang., A/in or A/lv mode, maximum angle corresponds to the angle that has to be carried
out.
SEQUENCE MENU:
- - - S E Q U E N C E - M E N U - - - -
O K
c h a n g e
E S C
q u i T
1 ) S e q
s e t :
1 4 7 3 9 8 1 2
2 ) S e q u e n c e :
O F F
1) Seq set:
you can set a sequence up to max. 8 programs. To set the next program in the sequence, press
OK.
2) Sequence:
It allows to enable or disable the sequence. ON = enabled; OFF = disabled.
