Fig. 3.3 Screw NOK
Errors can be:
-
“Under min time”:
when the torque is reached under the pre-set min time
-
“Over max time”:
when the fastening time is over the pre-set max time. In this case the
screwdriver will stop.
If the program you are in is finished, the unit will display the END CYCLE (fig. 3.4).
If the automatic reset is not active, this screen will be on until you push OK; instead if the automatic
reset is active, the unit will go to the next program.
Fig. 3.4 End program screen
In case of Sequence and last cycle, if the RESET is set on manual (fig. 3.5), push OK to re-start the
sequence; instead the unit will re-start the sequence automatically.
Fig. 3.5 End of sequence screen
Screw done display
This display shows the OK screws done. Its bigger digits ensure a more effective reading.
LED OK/ END/ NOK
To check more quickly the result of your fastening operation, 3 leds will help:
-
GREEN: Screw OK
-
YELLOW: end of program or end of sequence
-
RED: Screw NOT-OK
Beep sounds
Beep sounds at the end of the screwing allow to check if the screwing itself is correct or not.
-
1 beep: Screw ok
-
3 beep: Screw not-ok
-
5 beep: end of cycle
