Kolpa Kolpa-San ZEPHYR 1680 3F, Руководство пользователя

Страница: 11 / 40

10
www.kolpasan.eu
CLEANING and MAINTENANCE OF A MASSAGE BATH
CABIN
o
Children may not carry out cleaning or maintenance of the device if
unattended.
o
After completing the massage cycle, massage cabin shall be rinsed with
a jet of clean water and particles which might clog the openings in the
massage nozzle removed. Use a clean cloth to wipe the chrome parts.
o
Use only liquid cleansers and a soft cloth to clean.
o
To clean the acrylic and other kerrock or metal surfaces as well as to
remove lime scale KOLPA SAN SPECIAL CLEANER is recommended.
Spray the special cleaner on the surface or apply it with a sponge and
allow a few minutes to operate. Rinse with clean water. For valves with
a distinct sheen wiping the surface is recommended.
o
ATTENTION: The use of detergents in concentrations higher than
indicated in the appropriate instructions is not allowed.
o
ATTENTION: Cleaner operating for longer than 60 minutes may HARM
THE SURFACES of coloured elements and high-gloss elements
(chrome).
o
Descaling can also be done by using household vinegar which is more
effective when it warms up.
o
It is forbidden to use abrasive cleaning agents containing coarse fillers.
MAINTENANCE AND CLEANING INSTRUCTIONS
FOR SHOWER ENCLOSURE BALL BEARINGS
When cleaning the Kolpa San shower enclosures using the KOLPA SAN
SPECIAL CLEANING AGENT, which is very effective when it comes to
removing limescale and thorough cleaning of other components, make sure to
carefully adhere to the following instructions (the same applies to the
CLEANING LIQUID prior to the application of the protective coating):
- The cleaning agent should be left on to take effect for a maximum of 5
minutes.
- Afterwards, rinse off thoroughly with water for at least a minute, across the
entire surface of the casing of the ball bearing.
- Periodically check the movability of the turning part and the revolvable wheel.
Lubrication:
Wipe the bottoms of the lower and upper bearings with a cloth. When dried,
lubricate the balls, the revolvable cap on both bearings and the groove of the
profile with the KOLPA SAN lubricant for ball bearings.
For easier access to the ball bearings, we recommend taking the glass door
off the aluminium frame of the shower enclosure. This can be done in the
following manner: