Kollmorgen Digital MMC Control, Руководство по оборудованию

Страница: 217 / 322

Kollmorgen - December 2011 215
MMC Smart Drive Hardware Manual
-
S200-DLS DRIVE
8.1 S200-DLS Option Card
The S200 Option Card is located on the right side of the S200-DLS Drive. This section
explains in detail the various indicators and connectors located on the S200 Option
Card.
8.1.1 LED Indicators
There are three LED Indicators on the front of the Option Card, as described in Table
8-1 .
8.1.2 Diagnostic Indicator Details
The Diagnostic Indicator LED (labeled "D1" on the front of the Drive) performs various
functions:
• When Control Power is applied to the Drive, the Diagnostic LED turns on briefly as
the Option Card runs internal power-on diagnostics. If the diagnostics pass, the
Diagnostic LED goes off.
• If the Diagnostic LED is flashing after the power-on diagnostics are complete,
there is a problem with the Drive. See
section 10.2.4.1 on page 247 for blink code
details.
• While the Drive is operating, the Option Card is constantly monitoring Drive oper-
ation and performance. If a Warning or Fault condition is detected, the Diagnostic
LED will blink. See
section 10.2.4.1 on page 247 for blink code details.
8.1.3 Digital Link LEDs
There are two green LED indicators located between the "DLINK IN" and "DLINK
OUT" connectors.
• The right-most LED is associated with the "DLINK IN" connector, and indicates
that another "upstream" Digital Link device (Digital Link drive, Digital Control, Dig-
ital Link Accessory, etc.) is connected and successfully communicating with the
Drive.
• The left-most LED is associated with the "DLINK OUT" connector, and indicates
that the Drive is connected and successfully communicating with another "down-
stream" Digital Link device (Digital Link drive, Digital Link Accessory, etc.).
Table 8-1: LED Description for S200-DLS Option Card
LED Color Description
Diagnostic Yellow
The Diagnostic LED (labeled "D1" on the front
of the Drive), located in the top of the Option
Card, serves as the Option Card Status indica-
tor, and provides Option Card status and fault
information.
Digital Link LEDs Green
These LEDs, located between the "DLINK IN"
and "DLINK OUT" connectors, provide Digital
Link status information.