AKI-CDC-MOD-12T | HARDWARE REPLACEMENT
4.3
Replacing a CompactFlash or CFast Memory Card
The following is needed:
•
A new CompactFlash or CFast memory card.
•
A TX10 Torx screwdriver
Note:
Make sure to use adequate ESD protection.
Follow the steps below to replace a memory card:
1. Power off the operator panel.
2. Follow the instructions in chapter
Replacing the 2.5” SATA Mass Storage
to remove the front
frame assembly.
3. Install the new memory card in its intended slot illustrated in
fi
gure below.
Figure 4-4:
1. 2.5” SATA mass storage
2. CompactFlash slot
3. CFast slot
4. Reassemble in reverse order.
ky
Kollmorgen | October 2014
17
