AKI-CDC-MOD-12T | HARDWARE REPLACEMENT
4.2
Replacing the 2.5” SATA Mass Storage
The following is needed:
•
A new 2.5” SATA mass storage
•
A TX10 Torx screwdriver
Note:
Make sure to use adequate ESD protection.
Follow the steps below to replace the 2.5” SATA mass storage:
1. Power off the operator panel.
2. Remove the front frame assembly by removing the eight M3x8 Torx screws on the back cover
assembly.
Caution:
During disassembly, it is important to take care of the cable between the front and the rear
part. If you disconnect a cable, be sure that the right cable will be in the right position when
assembling.
Note:
The exchange of electronic components is only for experienced professionals.
Incorrect handling of electronic components or cables plugged in wrong, can lead to the
destruction of the device.
3. Remove the four M3x4 Torx screws on the two hard drive brackets. Remove the two hard drive
brackets.
4. Remove the two M3x6 Torx screws that are securing the brackets to the CPU board.
ky
Kollmorgen | October 2014
15
