8
9
OPERATING THE UNIT
W hen using the unit
When first using the dehumidifier, operate the unit
continuously 24 hours.
This unit is designed to operate with a working
O
O
O
O
environment between 5 C/41 F and 35 C/95 F.
If the unit has been switched off and needs to be
switched on again quickly, allow approximately
three minutes for the correct operation to resume.
Do not connect the dehumidifier to a multiple socket
outlet, which is also being used for other electrical
appliances.
Select a suitable location, making sure you have easy
access to an electrical outlet.
Plug the unit into a electrical socket-outlet with earth
connection.
Make sure the Water bucket is correctly fitted otherwise
the unit will not operate properly.
NOTE:
When the water in the bucket reaches to a certain
level,please be careful to move the machine to avoid it
falling down.
A dehumidifier operating in a basement will have little or no effect in drying an adjacent enclosed
storage area, such as a closet, unless there is adequate circulation of air in and out of the area.
Air outlet grille
Air intake
grille
20cm or more
20cm or more
20cm or more
20cm or more
40cm or
more
Positioning the unit
Do not use outdoors.
This dehumidifer is intended for indoor residential
applications only. This dehumidifier should not be used
for commercial or industrial applications.
Place the dehumidifier on a smooth, level floor strong
enough to support the unit with a full bucket of water.
Allow at least 20cm of air space on all sides of the unit
for good air circulation.
Place the unit in an area where the temperature will not
O
O
fall below 5 C(41 F). The coils can become covered with
O
O
frost at temperatures below 5 C(41 F), which may reduce
performance.
Place the unit away from the clothes dryer, heater or radiator.
Use the unit to prevent moisture damage anywhere books
or valuables are stored.
Use the dehumidifier in a basement to help prevent
moisture damage.
The dehumidifier must be operated in an enclosed
area to be most effective.
Close all doors, windows and other outside openings
to the room.
Removing the collected water
1. Pull out the bucket a little.
2. Hold both sides of the bucket
with even strength, and pull it
out from the unit.
3. Pour the water out.
There are two ways to remove collected water.
1. Use the bucket
When the unit is off,if the bucket is full, the unit
will beep 8 times and the Full indicator light will
flash, the digital display shows P2.
When the unit is on,if the bucket is full, the
compressor turns off and the fan turns off after
30 seconds for drying the water of the condenser,
then the unit will beep 8 times and the Full
indicator light will flash, the digital display
shows P2.
Slowly pull out the bucket. Grip the left and
right handles securely, and carefully pull out
straight so water does not spill. Do not put
the tank on the floor because the bottom of
the bucket is uneven. Otherwise the bucket
will fall and cause the water to spill.
Throw away the water and replace the bucket.
The bucket must be in place and securely
seated for the dehumidifier to operate.
The machine will re-start when the bucket is
restored in its correct position.
NOTES:
When you remove the bucket, do not touch
any parts inside of the unit. Doing so may
damage the product. Be sure to push the
bucket gently all the way into the unit.
Banging the bucket against anything or
failing to push it in securely may cause the
unit not to operate.
When you remove the bucket,if there is some
water in the unit you must dry it .
Fig.5
Fig.6
OPERATING THE UNIT
Casters(Install at four points on the
bottom of unit)
Do not force casters to move over
carpet, nor move the unit with water
in the bucket. (The unit may tip over
and spill water.)
NOTE:Casters is optional,some
models without.
