Kolibri KCS-2000, Руководство пользователя

Страница: 5 / 11

1.5 Control Panel
Name Function
BAT Selects preset batch quantities
(0, 10, 20, 25, 50, 80, 100, 120, 150, 200, 300, 400, 500)
SET Shows batch quantities set for each denomination. Also
used to set batch quantities for coin trays when pressed
for 3 seconds
+ (Plus) Increases batch quantity by a value of 1
Switches between value reporting and quantity reporting
Also used to set batch quantities for coin rolls when
pressed for 3 seconds
- (Minus) Decreases batch quantity by a value of 1
Also used to clear all batch quantities when pressed for
3 seconds
REPORT Shows value (or quantity) of coins counted for each
denomination
C Clears the display and resets the count
START/STOP Starts or stops operation of the machine
6
GETTING STARTED
2.
2.1 Powering Up
IMPORTANT: Before turning on KCS-2000, make certain no coins are present in the
coin hopper. This will cause an “EA” error when the KCS-2000 self-test is
performed. To clear the “EA” error, press the “START/STOP” button, then
empty any coins present in the coin trays
Plug the power cord attached to the KCS-2000 into a three-prong outlet. Turn on the
power switch located on the rear of the unit. The machine will conduct a self-check. The
main display will show “0” when the test has successfully completed
2.2 Counting
The KCS-2000 always operates in a batching mode by default. To enable simple
counting, all batch quantities need to be set to zero. To set batch quantities to zero,
press and hold the “-” button for approximately three seconds until “C” is displayed on
the left of the LED display.
• Before loading the hopper, make sure there are no uncounted coins remaining in it
from the previous count.
• To count coins, place them into the hopper and press the “START/STOP” button.
• The KCS-2000 will start counting and will automatically sort all coins into the
appropriate coin trays.
• The machine will automatically stop when all coins in the hopper are counted, or if the
batch quantity for any coin denomination is reached.
• To stop the machine, press the “START/STOP” button.
• To resume counting, press the “START/STOP” button.
• When a coin tray becomes full, stop the machine and empty the tray to ensure correct
machine operation. Stopping the machine will not alter or reset the count. You can
continue counting by pressing the “START/STOP” button.
• As it counts, the KCS-2000 will automatically display the total value of counted coins
on the screen.
5