7
Owner’s Manual
6HK13BEH0
Operation
CONTROL PANEL
When power is connected POWER lamp will be on.
1.
POWER BUTTON
- Activates unit when POWER BUTTON is pressed for 2 seconds. If POWER BUTTON is pressed for 2
seconds during operation, unit stops.
Note: It will take more than 10 seconds to start fans.
2.
FAN SPEED BUTTON
- Changes fan speed from (AUTO) to (MANUAL) when pressed.
- When MANUAL lamp is on, change fan speed between 1 and 6 step by pressing UP/DOWN BUTTONS.
- When AUTO lamp is on, fan speed is changed automatically between 1 and 6 step. When COOL mode, fan
speed starts in high speed. When HEAT mode, fan speed starts in low speed.
3.
TEMP SELECT BUTTON
- Choose temperature sensor by pressing this button shortly.
- When IN lamp is on, inlet temperature sensor works so it is used to control inside of a room.
- When OUT lamp is on, outlet temperature sensor works so it is used to provide cool air or hot air directly to
people or material.
- By pressing this button for 2 seconds, SET lamp will be on and SET mode activates. Then set the target
temperature by pressing UP/DOWN BUTTONS. After setting the target temperature, press TEMP SELECT
BUTTON for 2 seconds and SET lamp will be off and setting temperature will be memorized.
7
6HK13BEHO
Owner’s Manual
Oper on
CONTROL PANEL
1
. POWER BUTTON
vates unit when POWER BUTTON is pressed for 2 seconds. If POWER BUTTON is pressed for 2
seconds during oper on, unit stops.
2
. FAN SPEED BUTTON
- Changes fan speed from (AUTO) to (MANUAL) when pressed.
- When MANUAL lamp is on, change fan speed between 1 and 6 step by pressing UP/DOWN BUTTONS.
- When AUTO lamp is on, fan speed is changed automa cally between 1 and 6 step. When COOL mode,
fan speed starts in high speed. When HEAT mode, fan speed starts in low speed.
3
. TEMP SELECT BUTTON
- Choose temper
on shortly.
- When IN lamp is on, inlet temperature sensor works so it is used to control inside of a room.
- When OUT lamp is on, outlet temperature sensor works so it is used to provide cool air or hot air
directly to people or material.
- By pr
on fo
vates. Then set the
target temperature by pressing UP/DOWN BUTTO
er se ng the target temperature, press
TEMP SELECT BUTTON for 2 seconds and SET lamp will be off and se ng temperature will be
memorized.
When power is connected
POWER
lamp will be on.
1
2
3
4
5
9
6
8
7
Figure 9
Note :
It will take more than 10 seconds to start fans.
Содержание 6HK13BEH0
Страница 11: ...11 Owner s Manual 6HK13BEH0 11 6HK13BEHO Owner s Manual Table 1 1 Alarm Codes Table 1 1 Alarm Codes...
Страница 12: ...12 Owner s Manual 6HK13BEH0 12 6HK13BEHO Owner s Manual Table 1 2 Alarm Codes Table 1 2 Alarm Codes...
Страница 13: ...13 Owner s Manual 6HK13BEH0 Wiring Diagram 6HK13BEHO Owner s Manual Wiring Diagram Figure 13 6HK13BEHO...
