Owner’s Manual
6CC10BEA2AA00
16
17
Figure 22 – Removing Filters
Figure 23 – Removal of dust
Maintenance
FILTER CLEANING (Without flange)
There are 2 filters in the unit. The evaporator filter is located at the front of the unit. The con-
denser filter is located at the rear of the unit.
1. Open the front grill.
2. Slide filter up and use vacuum cleaner to remove the dust from the filter.
3. If the filter is heavily covered with dust and dirt, warm water and mild soap or neutral deter-
gent may be used to wash the filter. Do not use any other chemicals to clean filter, as they will
likely damage the filter.
4. Dry the filter in a shaded area before replacing it. Do not operate the unit without the filter
installed and the filter guard in the closed position.
5. Replace the clean filter and close the filter grill.
6. To clean the condenser filter, lift up on the rear filter from the middle bar slightly and then
angle the filter outwards from the bottom and remove.
7. Use the same cleaning procedure as above (3~5)
8. To replace the condenser filter, place the top of the filter in the guide and slide the filter up
until the bottom of the filter clears the frame.
Then push the bottom of filter into the guide and let filter into guide and let filter fall inside the
guide.
NOTE :
For effective cooling clean the filter at least every 2 weeks.
– Remove dust from the filter using a vacuum
cleaner hose attachment.
– If required wash the filter in lukewarm water
with a mild detergent. Leave to dry in a shaded
area before reinstalling.
– Pull the filter frame forward to remove the front
filter.
– Slide filter up and use a vacuum cleaner to remove
the dust from the filter.
– Lift up on the rear filter from the middle bar slightly
and then angle the filter outwards from the bottom
and remove.