Koldwave 5WK Series, Руководство по эксплуатации

Страница: 24 / 34

24
as follows:
1. Soak filter in solution of warm water and
detergent for 15 minutes.
2. Rinse in clean, hot water and shake excess
moisture from filter.
3. Spray one side of filter with light film of
oil.
4. Reinstall with oiled surface facing out
from unit.
Coils and Related Items
Coil Maintenance
The evaporator coil surfaces must be kept
clean of dirt and lint in order to operate at
rated efficiency. The coil should be
inspected on a regular basis and cleaned as
required.
CAUTION: Solutions used to clean coils
must not be corrosive to metals or
materials used in the manufacture of this
equipment. Take care to not damage the
coil or fins if using a high pressure spray
to apply the cleaning solutions.
Condensate Pump
Caution: Always disconnect the power
source before working on or near the
pump.
Pump Maintenance:
Do not touch or clean the sensor device with
sharp objects or tools. The sensor element is
fragile so handle with care. Replace the
pump if damaged in any way. If servicing,
clean carefully with a soft brush, cloth, or
under a slow running tap. Rinse out the tray
thoroughly.
Do not use solvent based cleaning agents.
Only mild detergents may be used, but rinse
thoroughly before refitting.
Do not use if the pump or its cable is
damaged in any way. Protect the cable and
tubing from sharp edges.
The condensate drain pan should be
periodically flushed.
Unit Storage
CAUTION:
If the unit is to be stored in an
unconditioned space where it will be
exposed to freezing temperatures, all
water must be removed from the
condenser coil prior to storage. Use 15 –
20 PSI of compressed air or nitrogen
applied to the Water In (middle)
connection. To do this turn the unit off.
Shut off the water supply. Disconnect the
3 hose manifold (Water Out, Water In,
Drain) from the unit. Place the unit in the
Cooling mode. Once the compressor
starts and runs for 15 seconds,
blow any remaining water out of the
condenser coil.