3
Warning
:
Use two or more people to move and install the ice maker. Failure to do so can result in
back or other injury.
Important
:
Do not remove any safety, warning, or product information labels from your ice maker.
Installing the Ice Maker
The ice maker should be installed by a licensed plumber in accordance with local electrical and
plumbing code requirements.
Before you plug the ice maker in, be sure to let it stand upright for at least 24 hours to allow the
compressor’s oils to settle.
Unpacking the Ice Maker
Carefully remove the packaging materials. Remove any shipping tape and glue from your ice maker
before using. Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners
to remove tape or glue. These products can damage the surface of your icemaker.
Types of Installation
This ice maker has been designed for freestanding, recessed, or built-in installation. In each case,
there must be adequate ventilation and access for service in a location where the ambient
temperature is between 50° and 100° F. Do not install near heat sources.
Freestanding installation:
Freestanding installation will allow you to install the icemaker in any place with access to a water
supply and a drain. You must follow the instructions for electrical requirements, water supply and
drain, and leveling the icemaker.
Recessed installation:
Recessed installation will allow you to install the icemaker under a counter or in a kitchen cabinet
provided the required clearance space around the ice maker is followed. This installation has the
same requirements as a built-in installation.
Built-in installation:
It is necessary to allow adequate ventilation space around the unit (make sure there is at least
some ventilation room for the back of the unit). The following additional items must be observed.
1. Place the ice maker in front of the installation location. Remove the feet and place the unit flat
on the floor or on a platform depending on your installation requirements.
2. The water supply pipe must be plumbed before connecting to the ice maker. Install the drain
line into your drain.
3. Turn on the main water supply and tap. Check for water supply connection leaks. Tighten any
connections (including connections at the tie-in).
4. If the electrical outlet for the ice maker is behind the cabinet, plug in the ice maker.
5. Push the ice maker into position.
6. Seal all around the cabinet to the floor with an approved caulking compound.