Tab locks into hole.
B
Step 1.
Remove and discard
protective plastic sleeve from ends of
rear brake assembly.
Step 2.
Position rear brake
assembly as shown, with brake levers
pointing towards stroller handle
(Figure A).
Step 3.
Push rear brake assembly
onto rear leg tubes at the same time.
Step 4.
Make sure plastic tabs on
rear brake assembly lock into holes
on rear legs as shown (Figure B).
Step 5.
Slide wheel onto axle
(Figure C).
Step 6.
Slide washer onto axle
(Figure C).
Step 7.
Fit straight part of cotter
pin through hole on axle as shown
(Figure D).
Step 8.
Line up tabs in each of
the hub caps with slots in the wheel,
snap hub caps into place.
Step 9.
Repeat for second side.
3
S50J-A 2/03
COTTER PIN
HUB CAP
WASHER
C
D
3
TO ASSEMBLE REAR WHEELS:
Step 1.
Snap top of footrest into
place until it clicks (Figure A).
Step 2.
Align clips underneath
footrest to frame of stroller as
shown (Figure B).
Step 3.
Push bottom of footrest
onto frame of stroller until it clicks
into place (Figure C).
4
TO ATTACH FOOTREST:
BRAKE ASSEMBLY
BRAKE ASSEMBLY
A
A
B
C
