ASSEMBLY AND OPERATING INSTRUCTIONS
LIKEtoBIKE 20
Please read this manual carefully before using the LIKEtoBIKE for the first time!
The assembly must be done by an adult!
1. Remove all packaging materials. Contents of the enclosed acces-
sory box are: Pedals, hexagon tool (Allen key) (4mm,5mm,6mm),
Front and Rear Reflectors, Touch-up paint, Instructions.
2. After loosening the seat post clamp screw, slide the seat post
into the seat tube.
Important: Please note the minimum insertion depth of
the seat post! This is indicated by a line marked on the
seat post! The seat post must not be pulled out beyond
this mark, otherwise a secure connection to the down
tube is not guaranteed! The saddle can be adjusted in the lon
-
gitudinal direction and inclination after loosening the saddle
fastening screw. Then tighten this screw again!
Adjusting the correct saddle height:
Place a pedal in the lowest
position. If the child is sitting on the saddle, the child must be able
to touch this pedal with his heel (outstretched leg). Make sure that
the childs hips stay level and do not tip over to the side!
Seat post
clamping screw
Right Pedal
Left Pedal
4. Now mount the pedals. Turn the pedal axles by hand until snug!
Then tighten with a 15 mm wrench.
Important: The right pedal is mounted clockwise, the
left pedal counterclockwise! The pedals are marked on
the pedal axle with an „R“ for the right pedal and an „L“
for the left.
It is important to remember this if you need to
loosen the pedal axle someday. So that the pedals can easily be
loosened again later, grease them lightly before mounting.
After the first long ride please check that the pedals are
seated firmly! Loose pedals could damage the thread of the
cranks or cause a fall!
3. 3. Insert the stem with the already mounted handlebar onto the
steering tube.
Now align the handlebar in the direction of travel at the desired
height and tighten the height adjustment screw with a 5 mm Allen
key (torque 10 Nm).
Under no circumstances may the stem be mounted over the
upper edge of the steering tube!
After loosening the angle adjustment screw, you can fine
tune the handlebar position by changing the stem angle. Then re
-
tighten the angle adjustment screw (torque 10 Nm).
Use the headset adjustment screw to adjust the headset.
Very important: With this screw you adjust only the
headset clearance! This screw is not used to attach the
stem!
Adjustment for
headset clearance
(NOT TO FIX THE
STEM!)
Angle adjustment
screw
Steering tube
Height
adjustment screw
Saddle fastening
screw
