Koike Sanso Kogyo WEL-HANDY MINI, Руководство по эксплуатации

Страница: 28 / 46

WEL-HANDY MULTI
25
Caution
When inserting the wire, do not bring your head near the wire that
comes out of the tip.
Your eyes can be damaged.
6 Press the tracing roller against the vertical plate, and set the carriage
in the welding position.
7 For attraction by the magnet, incline the magnet lever as shown in
Fig.3.
8 Turn the handle of the slide unit assembly (UP/DOWN or FRONT/
REAR) for the torch position alignment.
9 Select the welding direction and set the welding speed.
10 Determine the start position.
11 Set the welding conditions by means of the welding power supply.
12 Press the start boson switch, and start welding. (Arcs will be
generated at the same time.)
Caution
Pay attention to the following during welding.
Wear a welding mask, face guard, and welding protectors to protect
yourself from arc light, fumes, and spatters.
13 Finely adjust the welding conditions (current, voltage, speed, etc.) as
necessary.
14 Welding can be stopped by means of the stop switch or auto stop
switch. (While the carriage stops, arcs stop at the same time.)
Wel Handy.book Page 25 Wednesday, April 10, 2002 4:00 PM