-6-
Fig.#13
13
Carefully thread the screws into the
brackets, until toilet is secure.
Alternately tighten left and right sides
to prevent pulling the toilet off center.
Install cap to cover screw.
Do not overtighten.
Cap
Screw
Bushing
Fig.#14
14
Apply caulk around base.
TO CONNECT WATER
SUPPLY
* Flexible hose are recommended to
connect the supply line to the fill valve.
If you use a rigid connection (not
provided), take care not to apply side
forces to the bottom of the fill valve. Be
sure the rigid connection must be fit
with supply line completely to prevent
damage shank by forced connection.
(
)
Supply Shank*
Supply Shut-Off Valve
Fig.#15
15
IMPORTANT:
Make certain the top is turned to the locked
position. Valve may not turn on if top is not fully in the
locked position.
Before turning on the supply valve for the first
time, follow the steps below to clear sand, debris and rust
from the system:
Make sure water sure water supply is off. Remove valve END
by rotating it 1/8 turn counterclockwise.
While holding a container over the uncapped VALVE to
prevent splashing, turn water supply on and off a few times.
Leave water supply off.
Replace END by engaging lugs and rotating 1/8 turn
clockwise.
Turn on water supply. Check that water level is at the marked
water line.
1/8
1/8
1392769-T01-A
