10
111889-
CA
(1093)
Kohler Co., Kohler WI
7. INSTALL WHIRLPOOL
A. WHIRLPOOL SET-IN
CAUTION: Risk of product damage. Do not use
the piping or pump for structural support or
positioning.
Slide new bath into position. Insert tailpiece into trap.
Shim under whirlpool feet as necessary with metal shims
to level. Bath must be level and resting on all four feet.
Check for level along the top of the side of the whirlpool
and across the drain end. Whirlpool may have to be
moved in and out of recess area until shimmed properly
if feet are not accessible from back or side.
NOTICE: Whirlpool pump and control extends
1-1/8” beyond the outer edge of the whirlpool at the
rear jet area. Modify the framing in this area to
accommodate the piping.
Metal Shims
Metal Shim
B. INSTALL PLUMBING
CAUTION: Risk of damage to whirlpool
bottom and subfloor. Ensure watertight seal on
bath drain connections.
1.
When whirlpool is securely positioned, connect
drain into trap. An access panel will simplify future
maintenance.
Connect Here
2.
Install the faucet valving and spout tee. The deck
must be finished before handle trim and spout can
be installed. Open hot and cold valves and check all
supply connections for leaks.
3.
Run water in whirlpool and check drain connection
for leaks.
8. ABOVE THE FLOOR INSTALLATION USING THE K-1172
OPTIONAL ADJUSTABLE LEGS
It is possible to install the bath whirlpool above the floor
with the use of the optional K-1172 legs. These legs
adjust about 3/4” in height adding a minimum of 2-3/4”
and a maximum of 3-1/2” in height.
For installation of the optional adjustable legs, refer to
instructions packed with K-1172.
