9
10
11
12
13
9
14
11
How to Connect the Wires
□
Connect the blue connectors to the blue terminals on
valve box. The white lines on the connectors should face
the front of the valve box.
NOTE:
After all wires of the valve box are connected, it
will take 15 seconds to start working.
How to Install the Valve Box
IMPORTANT! Risk of restricted waterflow.
The outlet hose(9) must not be taut or kinked when
installed.
NOTE:
Tighten the outlet hose connector by hand.
Do not use a pliers or a wrench.
□
Thread the outlet hose(9) onto the valve inlet(10).
□
Slide the valve box(11) into the mounted bracket.
□
Connect hose(12) to the valve box outlet(13). Make
sure it is securely connected in place .
□
Ensure that all connections are tight.
□
Ensure that the handle is in the off position.
□
Turn on the main water supplies and drain.
□
Check all connections for leaks. Repair as needed.
□
Remove the aerator. Turn on the faucet, run hot and
cold water about one minute to remove any debris.
Remove any debris from the aerator. Shut off the faucet.
Reinstall the aerator.
How to Clean Inlet Screen of Valve Box
□
Turn the handle to the closed position.
□
Disconnect the outlet hose(9) from the valve box(11).
□
Remove and clean the inlet screen(14) from inside the
valve box.
□
Reinstall the inlet screen and reconnect outlet hose.
Supply Hose
Aerator
Supply Stop
Blue Terminals
& Connectors
Hose
Valve Box
Outlet Hose
Blue Connectors
Blue Terminals White Lines
Bracket
CARE AND MAINTENANCE
INSTALLATION CHECKOUT
1439190-T2-A
4
