Kohler REVIVAL K-14241, Руководство по установке

Страница: 4 / 24

4 1010439-2-
A
Kohler Co., Kohler, WI U.S.A.
TO CONNECT SUPPLY SHUT-OFF VALVE
NOTICE: Read this section carefully before performing
these steps.
For installation of the supply shut-off valve, refer to the
installation instructions packed with the valve. Carefully
bend the tubing to fit.
Cut the end of the tubing 1/4” (6mm) longer than the
distance between the supply shut-off valve and the
supply shank. Remove any burrs from the inside of the
tubing.
Slip the coupling nut, compression nut, and ferrule onto
the tubing. Insert the tubing into the supply shut-off valve
and the supply shank, positioning the seal washer
(supplied) or the compression washer (not supplied), as
shown. Hand tighten the coupling nut, and then tighten
the compression nut.
Fig. #7
Tubing
Ferrule
Supply Shank
Seal Washer
Coupling Nut
Compression Nut
Supply Shut-Off Valve
Compression Washer
Tubing
Coupling Nut
Compression Nut
Ferrule
Open the supply shut-off valve and check all
connections for leakage. If the connections have been
properly assembled, a slight retightening of the nuts
should stop any leakage.
If the toilet is leaking between the tank and the bowl,
carefully retighten the three brass nuts evenly.
Periodically check all the bowl and tank connections for
leakage for several days following installation.
CAUTION: Risk of product damage. The valves
and fittings in this toilet require no adjustment. Any
attempt to adjust the fittings can damage the
product. Such adjustments or any modifications of
the product are not considered normal usage, and
will void the warranty.
Fig. #8