8.
Assembly instructions
1. Locate and remove all loose parts from the
carton.
2. Cut four corners of the carton from top to bottom
and lay the panels flat.
3. Slide the handle assembly (G) onto the frame (H)
and secure with saddle bolts and knobs.
NOTE:
Risk of personal injury. Avoid placing hands
between handle and frame when assembling to
prevent pinching.
4. Remove colored quick connect nozzles (K) from
plastic bag and insert them into nozzle holder (L).
NOTE:
Nozzles are color coded to match colored
nozzles on panel.
5. Connect wand (E) to gun (D). Tighten securely.
6. Attach high pressure hose (C) to gun (D). Tighten
securely.
NOTE:
The engine is shipped without oil. Before
starting engine, add the correct amount of oil recom
-
mended oil (SAE30). Damage to the engine will
occur if the engine is run without oil, this damage will
not be covered under warranty.
NOTE:
The high-pressure pump was filled with oil at
the factory. Always check oil level before using (refer
to Maintenance for more information).
Pressure Washer Terminology
PSI (Pounds per Square Inch):
The unit of meas-
ure for water pressure. Also used for air pressure,
hydraulic pressure, etc.
LPM (Litres Per Minute):
The unit of measure
for the flow rate of water.
CU (Cleaning Units):
LPM multiplied by psi
equals CU.
Bypass Mode:
Allows water to re-circulate within
the pump when the gun trigger is not pulled. This
feature allows the operator to release the trigger gun
and reposition themselves without having to turn the
engine off in between cleaning actions.
NOTE:
Allowing the unit to run for more than two
minutes without the gun trigger being pulled could
cause overheating and damage to the pump. Do
not let the pressure washer run for more than two
minutes in Bypass Mode. Turn off the engine and
relieve the pressure in the gun during these
extended situations.
Thermal Relief Valve (Q):
When
the temperature inside the pump
rises too high, this valve will open
and release a gush of water in an
effort to lower the temperature
inside the pump. The valve will
then close.
Detergent Injection System:
Mixes cleaners or
cleaning solvents with the water to improve cleaning
effectiveness.
Water Supply:
All pressure washers must have a
source of water. The minimum requirements for a
water supply are 20psi and 20 litres per minute.
If your water source is a well, the garden hose length
can only be 30ft. (9m) max.
WARNING:
To reduce the possibility of
contamination always protect against
backflow when connected to a potable water
system.
7109782 PS3395 EuroQuip Manual.indd 8
4/4/2017 9:44:00 AM
