-3-
1079129-T01-U
INSTALLATION
1. Remove the Existing Toilet
·
·
·
Turn off the water supply.
Flush the toilet, then sponge out all remaining water from
the tank.
Disconnect the supply shut-off valve(if present), and
remove the old bowl and tank.
CAUTION: Risk of hazardous gases.
If the new toilet
is not installed immediately, temporarily stuff a rag in
the closet flange.
1.
·
·
·
(
)
(
)
2. PREPARE THE SITE
Ensure the rear bowl contacts the finished wall and mark the
outline of bowl base on the floor with pencil. Mark the
mounting hole centerline on the floor per width of the bowl.
2.
Finished
Wall
Rear
Bowl
3. INSTALL THE TANK (CISTERN)
Carefully turn the tank (cistern) upside down onto a protected
surface. Place the gasket with the tank (cistern).
Position the tank (cistern) on the bowl (pan) by centering the
gasket on the bowl (pan) inlet. Line up the tank (cistern) and
bowl (pan) screw holes.
Overtightening
may cause breakage or chipping of the vitreous china.
Assemble the retaining washer and rubber washer to the
screw. Securely tighten the screws so the tank (cistern) is
level.
Be sure the screws are tight enough to achieve a watertight
seal.
CAUTION: Risk of product damage.
3.
Bolt
Tank
Bowl
Washer
Rubber Seat
Nut
E-Ring
E
Gasket
