Kohler Mira Eco, Инструкция по установке и эксплуатации

Страница: 10 / 13

10
USER MAINTENANCE
If you require a Mira trained service engineer or
agent, refer to section:
‘Customer Services’ .
Fault Diagnosis
Symptom:
No flow or low flow rate from shower
•
fi ttings.
Cause / Rectifi cation:
Spray plate blocked, clean or renew.
•
Make sure that the hose is not blocked or
•
twisted.
Head of water below minimum required (Min
•
supply pressure 0.5 Bar)
Problem with the shower control, refer to your
•
shower control installation and user guide.
—————————————
Symptom:
Drip from the showerhead.
•
Cause / Rectifi cation:
A small amount of water may be retained in
•
the showerhead after the shower control has
been turned off. This is quite normal, changing
the angle of the showerhead may vary the
draining time.
Problem with the shower control, refer to your
•
shower control installation and user guide.
—————————————
Symptom:
Shower temperature changes when spray
•
action is adjusted.
Cause / Rectifi cation:
Adjusting the spray action changes the fl ow of
•
water. This may affect some shower controls
and plumbing installations. To minimise
the effect make sure that the spray plate is
clean.
Cleaning
Many household cleaners contain abrasives and
chemical substances, and should not be used for
cleaning plated or plastic fi ttings.
These fi nishes should be cleaned with a mild
washing up detergent or soap solution, and then
wiped dry using a soft cloth.
Use your thumb or a soft cloth to wipe any
limescale from the soft nozzles and the front
surface of the showerhead spray plate.
Important! The spray plate must be regularly
cleaned to make sure that the showerhead does
not become blocked.
Spray Plate Assembly - Internal
1.
Remove the spray plate assembly.
2.
Clean all the components with a stiff brush.
If necessary use a plastic kettle descalent
in accordance with the manufacturer's
instructions. Flush thoroughly with water
before the shower is used.
3.
If necessary replace the 'O' seals. Refer to
section: Spare Parts.
4.
Refi t the components in reverse order. Make
sure that the 'O' seals and the inner and outer
nozzle retaining rings are fi tted correctly.
Showerhead
Body
Outer Nozzle
Ring Retainer
Inner Nozzle
Ring Retainer
Spray Plate
Assembly
Adjuster Ring
'O' Seals