19
1493936-W2-A
Read the section
“IMPORTANT SAFETY INFORMATION”
first.
Switch off the electrical
supply.
A small amount of water
may continue to drain
over a few minutes.
10
11
Warning!
Turning the
shower off and back on
during showering may result
in unstable temperatures
at the showerhead. Always
ensure the temperature has
stabilised before re-using
the shower.
Switch on the electrical
supply.
Push power button for the
desired output. The button
illuminates.
P u s h S TA RT / S TO P
button. Light in the button
illuminates.*
1
3
2
MAX
HIGH
ECO
LOW
TEMPERATURE
POWER
BOOST
TEMPERATURE
TEMPERATURE
Adjust temperature as
required.
Allow 10 - 15 secs for any
temperature adjustments
to stabilise and reach the
showerhead.
Check water temperature
before entering shower.
4
6
5
0
15
COLD
HOT
H
Push START/STOP button.
Light in the button goes out
and shower continues to
run for a few seconds.
8
9
7
Push Airboost button if
required. The Airboost
button will illuminate and
briefly flash.
Aerated water flows from
the Showerhead
MAX
AIRBOOST
Normal
Flow
Airboost
Enabled
Airboost
Enabled
Normal
Flow
*
Airboost pump runs for 2 seconds to purge the air system.
Note:
When the shower is
not
running or the STOP button has been pressed, the three white power button lights will
fade to dim after a short time, indicating the shower has entered a "stand-by" mode.
A slight hissing sound may also be heard from the shower during operation. High mains water pressure and high shower
temperatures will affect the tone. This is quite normal in use.
Operation
