- 42 -
KD 477-2 Workshop Manual_cod. ED0053029370_
1° ed
_ rev.
00
XIV
90
89
88
91
0,15 mm
intake/exhaust
Checking oil pressure
1
. Remove union from rocker oil hole and fit a pressure gauge gra-
ded from
0
to
8 kg/cm²
(fig. 90).
2
. Start engine and run up to
3000 RPM.
Wait for the oil temperatu-
re to reach 70 to 80°C.
3
. With engine idling at
3000 RPM
the pressure gauge needle
should be slightly over half way corresponding to a pressure of
3
to
4 kg/cm².
Said pressure will stabilize at
2
to
3 kg/cm²
when engine runs at
full load and the oil temperature exceeds 70 to 80°C.
4
. Reduce revs to minimum. The pressure should not fall to under
1
kg/cm²
with the oil temperature exceeding
80°C.
Checking for oil leaks
1
. Remove exhaust gas collection pipe from suction manifold and
close with a plug (fig. 91).
2
. Start engine and run for a few minutes. The pressure which
forms inside the crankcase bring out any oil leaks.
3
. Re-fit gas collection pipe to suction manifold.
5
. Re-fit rocker covers and sealing gaskets.
ENGINE TESTING
Speed adjustment
1
. With engine hot set minimum speed at
1000 RPM
(fig. 88) and
maximum to idle (fig. 89) at:
3150 RPM
for engines at 3000 rpm
3750 RPM
for engines at 3600 rpm
2
. Then stop the engine.
3
. Remove injectors, clean nozzle holes carefully, check setting and
re-fit.
4
. Adjust clearance between valves and rockers, while engine is
hot, to: