Kohler KARAT K-23883, Инструкция по установке и эксплуатации

Страница: 4 / 8

4
1402868-X2-A
For Wood Countertops
Mark and pre-drill the wood screw holes at the locations shown on
the template.
Waterproof any exposed areas of wood.
For Marble/Stone Countertops
Position the countertop upside down on foam padding to protect
the surface. Mark and drill 3/8” holes 5/8” (1.6 cm) deep at the
locations shown on the template.
Use a setting tool and hammer to secure the anchors.
For All Installations
If the countertop has not been installed, install it at this time.
Drill the faucet holes according to the faucet installation instructions.
Position the lavatory squarely under the cutout before tightening
the clamps. Draw the lavatory rim up against the countertop until
it is snug.
Do not overtighten.
Immediately wipe away any excess sealant, and fill any voids as
needed.
Allow the sealant to set for 30 minutes before proceeding.
Connect and tighten the trap to the drain, and complete the water
supply connections to the faucet according to the instructions
packed with the faucet.
Run water into the lavatory and check for leaks.
Clean up with a non-abrasive cleaner.
For wood, wood composite, and marble countertops, install the
lavatory to the countertop with the clamps and screws provided.
For other countertop materials, refer to the countertop manufacturer’s
instructions for recommended fasteners.
CAUTION:Risk of personal injury or product damage. Handle
with care. Vitreous china can break or chip if the product is
handled carelessly.
CAUTION: Risk of product damage.
Overtightening the nuts
may cause irreparable damage to the lavatory.
Install the faucet to the countertop according to the faucet
manufacturer’s instructions.
Install the drain to the lavatory according to the drain manufacturer’s
instructions.
NOTE:
Do not use adhesives or adhesive sealants.
Apply a continuous bead of quality sealant to the top surface of the
lavatory rim where it will contact the countertop.