2. Rigid Supply Tee Installation
Insert the plastic gasket and the rubber washer into the top of the
supply sleeve.
Slide the metal washer onto the spout shank.
Thread the shank nut up onto the spout approximately 1
″
(2.5
cm).
Thread the supply tee to the spout shank until it is hand tight.
Tighten the hex-end of the supply tee with a wrench. Ensure that
the tubes are aligned to the sides. Do not overtighten.
Slide the metal washer down the shank to the rigid supply sleeve.
Thread the shank nut down to the washer. Securely tighten with
a wrench. Do not overtighten.
Spout
Shank
Shank
Nut
Plastic
Gasket
Tee Supply
Sleeve
Rubber
Washer
Tee Supply
Hex-End
Washer
117121-2-AB
4
Kohler Co.
