-5-
Step 3: Installing Filter Cartridge & Replacing Filter
Cartridges
·
·
·
Remove and discard the dustproof cap (sanitary
protective cap) from the cartridge;
Verify both O-rings are present and positioned correctly in
the grooves;
Push the filter cartridge Leve1 (blue color matching icon )
into the filter base on the left side and the filter cartridge
Leve2 (orange color matching icon ) on the right side,
align the hollow icon of the cartridge with the hollow icon
on the filter base, press the cartridge deep into the water
base, then turn cartridge clockwise until the hollow icon of
the cartridge were aligned the color filled icon on the filter
base, it will be fully installed. (Figure 8)
Step 4: Test System
NOTE:
·
·
·
Turn on the water filtration faucet;
Slowly turn on the cold water supply valve, Run water to
flush trapped air;
It is normal for there to be Residual air in the
System causing bubbles (temporary cloudiness) in the
water.
Turn off the water filtration faucet, Keep the cold water
supply valve turned on for 15 minutes. Check all fittings
and tubings for leaks. If it leaks, see Troubleshooting.
Step 5: Flush Filter
·
Turn on the cold water supply valve and the water
filtration faucet, run water for a minimum of 10 minutes to
flush, The system installation is now complete and ready
to serve filtered water.
·
·
·
O
(
)
(
)
60
(
8)
·
·
·
(
)
15
·
10
a
b
c
Figure 8
8
1211428-T01-A
