2. Determine the Bracket Location
If the water supply was not turned off previously, turn off the
water supply to the toilet.
If there is still water in the tank, flush the toilet to remove most
of the water from the tank.
Close the toilet seat and seat cover to avoid dropping parts in the
bowl.
Remove the tank lid and with the back of the lid toward you
position it upside down on the seat cover or a surface covered
with a towel or other soft material.
Recommended:
For tank lid stability, install four pads, two on the
front and two on the back, near each corner of the tank rim
where the lid contacts the tank rim. The pads stabilize the lid,
helping to stop false flushes when the lid is bumped.
Position the module upside down on the right side of the lid,
against the inside of the lid ledge.
Position and hold the bracket on the back ledge as shown.
Note the number of the slot closest to the bottom tab.
6
4
3
2
1
5
Slot
Bottom Tab
Ledge
Bracket
Back of Lid
Module
Tank Lid
Top Tab
6
4
3
5
Pad
1216369-2-D
6
Kohler Co.
