Kohler K-1315, Руководство по установке

Страница: 9 / 48

9. Secure the Bench or End Panel
Tighten the bench or end panel bolts and hex nuts which are loosely assembled to the corner post.
10. Secure the Nailing-in Flanges and Install the Optional Apron Frame
Drill a small pilot hole through the side nailing-in flange at each stud. Add shims between the side
nailing-in flange and the studs as needed to eliminate gaps.
Nail 1/4
″
(6 mm) thick furring strips to the side studs to shim out to the edge of the nailing-in
flange.
Use #6 large-head galvanized nails to secure the side nailing-in flange to the studs.
Repeat these steps for the receptor/bench or end panel.
Install the optional apron frame according to the instructions packed with the apron.
11. Secure the Corner Post Adjustment Bracket
Securely tighten the corner post adjustment bracket nuts.
12. Install the Plumbing
CAUTION: Risk of property damage. Ensure a watertight seal on the whirlpool drain.
Connect the drain to the trap according to the drain manufacturer’s instructions.
NOTICE: An access panel will simplify future maintenance.
Install the faucet valving according to the faucet manufacturer’s instructions. Do not install the
faucet trim until instructed. Open the hot and cold water supplies, and check the supply
connections for leakage.
Run water into the whirlpool, and check the drain connections for leakage.
Back Side of
Bench or Side
Panel
Corner Post Adjustment
Bracket Nuts
Tighten the
hex nuts.
Nail 1/4" (6 mm) thick furring
strips to the side studs.
Drill small holes through
the side nailing-in flange
8" (20.3 cm) apart.
Use #6 large-head galvanized
nails to secure the side nailing-in
flange to the studs.
Stud
Corner Post
Kohler Co. 9 1022405-2-C