Kohler HYDRO-TOWER 300, Руководство по установке

Страница: 12 / 18

-12-
2. Make sure of h according to dimensions of bowl and then
locate the installation hole of fixing bracket. Mark on the
wall for appropriate position for fixing bracket, and drill four
holes with diameter of 10mm and depth of 80mm with
churn drilling as shown in illustration, and fill in the holes
with bulge screw and tighten the screw to set the fixing
bracket.
Note: Ensure the fixing bracket to remain level.
2. h
10mm 80mm O
Fixing Bracket
Bulge Screw
Gasket
Spring
Nut
h
3. Put the tank onto the fixing bracket as shown in the right
figure and adjust the tank to level . Then tighten screws
with hex-head key. Note: it is a must to keep the tank level.
Connect the inlet hose with tank inlet pipe.
Note: 1. Ensure water tank internal valve is OFF.
2. Suggestion: connect a temporary rubber or plastic
hose on valve, flush water supply pipeline. Ensure
water is clean, no residual sand stone or fouling
inside pipeline.
3.
1.
2.
Water Pipe
Screw
Level
Tank
Tighten
Loosen
Medium
Allen Key
Connecting Pipe
Mask
Screw
Water Tank
Protective Cover
4. Install the mask in the block screen of the tank, and
tighten the screw to fix the mask to the tank.
4.
5. Insert the inlet pipe and drainage pipe into the bowl, and
then adjust the syphon and drainage pipe to a proper
position to be fixed into the bowl. Make sure of the
positions of syphon and discharge elbow and then remove
the bowl.
5.
Inlet Pipe
Syphon
Discharge Elbow Drainage Pipe
1263048-T01-C