Attach second Wall Retainer
P
7
Check that the Door Assembly
top edges are level.
10
Fit top and bottom hinge caps.
(Note: bottom cap has ‘wings’.)
11
position against the wall.
8
Centralise Door Assembly
9
Slide drip edge seal over wing
on bottom hinge cover and
Repeat between hinge cover
and door magnet extrusion.
12
door edge extrusion enough to slip
drip seal moulding underneath.
(Note: Drip seal moulding and
retainer and ‘handed’).
glass and pull into contact with
door edge extrusion. Clamp in
place using the bracket and No. 6
screw.
13
NOTE: DOOR ASSEMBLY MUST BE
PLUMB USING A SPIRIT LEVEL.
Fit the other small screw to the top
hole in the door edge extrusion.
front of the shower base.
Check vertical with spirit level and
remaining long scews. Ensure the
screws go into the stud.
Fit all 6 screw caps.
10 mm
1310239-A02-A 10/01/2017
-4-
trim seal
flush with
door glass
