Kohler Command 6 HP XKE Series, Руководство пользователя

Страница: 7 / 16

7
Stopping
1. If possible, remove the load.
2. Move the throttle control to the “slow” or “low”
idle position. Allow the engine to run at idle for
30-60 seconds.
3. Move the switch into the “stop” position.
Operating
Angle of Operation
This engine will operate continuously at angles up
to 20°. Check oil level to assure crankcase oil is up to
the point of overfilling the filler neck.
Refer to the operating instructions of the equipment
this engine powers. Because of equipment design or
application, there may be more stringent restrictions
regarding the angle of operation.
NOTE: Do not operate this engine continuously at
angles exceeding 20° in any direction. Engine
damage could result from insufficient
lubrication.
Cooling
NOTE: If debris builds up on the grass screen or
other cooling air intake areas, stop the engine
immediately and clean. Operating the engine
with blocked or dirty air intake and cooling
areas can cause extensive damage due to
overheating.
WARNING: Hot Parts!
Engine components can get extremely hot from
operation. To prevent severe burns, do not touch these
areas while the engine is running–or immediately after
it is turned off. Never operate the engine with heat
shields or guards removed.
Maintenance Instructions
WARNING: Accidental Starts!
Disabling engine. Accidental starting can cause severe injury or death. Before working on the engine or
equipment, disable the engine by disconnecting the spark plug lead(s).
Maintenance Schedule
These required maintenance procedures should be performed at the frequency stated in the table. They should
also be included as part of any seasonal tune-up.
¹Perform these maintenance procedures more frequently under extremely dusty, dirty conditions.
²Have a Kohler Engine Service Dealer perform this service.
Daily or Before
Starting Engine
Maintenance Required Frequency
• Fill fuel tank.
• Check oil level.
• Check air cleaner for dirty¹, loose, or damaged parts.
• Check air intake and cooling areas, clean as necessary¹.
After First 5 Hours • Have valve to rocker arm clearance checked².
• Service precleaner element¹.
• Change oil.
Every 25 Hours
• Replace air cleaner element¹.
• Remove cooling shrouds and clean cooling areas¹.
• Check spark plug condition and gap.
• Have valve to rocker arm clearance checked².
Every 100 Hours
Annually