Kohler BATH WALL, Руководство по установке

Страница: 7 / 9

ENGLEFIELD
INSTALLATION INSTRUCTIONS
Page 7
Carefully measure and mark pattern on wall
board surface as shown in figure 11 .
This pattern applies to:
NOTE: Measurements from edges, top and
base. All dimensions below are in millimeters.
• Flat shower walls
• Flat bath walls
• The flat sections of
moulded walls
DURACRYL WALL INSTALLATION CONT...
30
50
30
250
300
80
Adhesive
Pa
tter
n
Pattern on wall board
Adhesive
Pa
tter
n
Pattern on rear of wall liner Pattern on wall board Pattern on rear of wall liner
W
all Liner position already marked
Tray recess Tray recess
CORNER CORNER
Fig.11: Adhesive pattern for Flat Walls
MARKING ADHESIVE PATTERN
For moulded shower walls, the pattern must be marked on both wall board and rear of Duracryl liner.
Refer to
fi
gures below for both patterns: • Corner Contour & Corner Contour PLUS Wall -
• Side Recessed Wall -
At this stage it is essential that the back side of the Duracryl wall and the surface of the wall board
are wiped clean with a damp cloth. This will ensure that all dust is removed from both surfaces and
provide a clean surface for the adhesive. Allow both surfaces to dry before adhesive application.
Fig.12: Adhesive pattern for Corner
Contour and Corner Contour PLUS Walls
30
50
30
410
450
80
Adhesive
Pa
tter
n
wallboard
recess
wallboard
recess
Packing Blocks
*Leave top block intact
to support the shelves.
*Carefully cut the lower
block to fit around nog.
W
all Liner position already marked
CORNER CORNER
Fig.13: Adhesive pattern for
Side Recessed Walls
Mark the pattern but do not
apply adhesive at this stage.
When applying adhesive
it is vital to leave gaps in the
bead to allow solvent curing.
!
IMPORTANT
figure 12
figure 13
Adhesive
Pa
tter
n
30
30
80~100
Pattern on wall board
Adhesive
Pattern
W
all Liner position already marked
Tray recess
CORNER
DURACRYL WALL